Causes, phenomena and treatment methods of abnormally high temperature of SKF operation

Home » Company Dynamics » Causes, phenomena and treatment methods of abnormally high temperature of SKF operation

Causes, phenomena and treatment methods of abnormally high temperature of SKF operation

Views: 0 Author: Site Editor Publish Time: 2024-09-25 Origin: Site

Causes, phenomena and treatment methods of abnormally high temperature of SKF operation

1. Causes of high temperature of SKF bearings:

(1). It is possible that the cooling water of SKF bearings is interrupted, causing high temperature.

(2). It is possible that the oil quality of SKF bearings is deteriorated, the oil itself is not clean or the oil is deteriorated during operation.

2. Phenomenon of abnormal high temperature operation of SKF bearings

The digital thermometer monitoring system of SKF bearings sends a fault signal of increased bearing temperature.

3. Treatment methods for abnormal high temperature of imported bearings.

(1) Low oil pressure may cause the cooling water hydraulic valve to close. The oil pressure of the speed regulator should be checked first.

(2) Check whether the cooling water pipeline system is normal. If the cooling system is blocked, stop the machine immediately for processing.

(3) Check whether the bearing has abnormal sound and detect whether the bearing swing is abnormal.

(4) Check the quality of the engine oil and whether the oil level of the oil gauge is normal.

SKF Bearing

Hot News

How to deal with stick-slip of bearing roller conveyor chain?

The bearing roller conveyor chain is sticky and slippery, and the production line is frequently interrupted, which reduces work efficiency, causes severe corrosion, and shortens the service life.Treatment method for sticky and slippery bearing roller conveyor chain:Even if the bearing roller conveyo
Five things to note when bearing operation

1. Mechanical damageIn severe cases, metal peeling and large-scale messy scratches occur on the contact surface; generally, bearing mechanical damage refers to the presence of grooves of varying degrees on the alloy surface of the bearing. The main reason for the mechanical damage of the bearing whe
Defects caused by heating of forgings

Beryllium oxide: Beryllium oxide not only causes a large loss of steel, but also reduces the surface quality of forgings and the service life of forging dies. If it is pressed into the metal, it will cause the forgings to be scrapped. Failure to remove beryllium oxide will affect turning.Decarburiza
How much does moisture affect bearing life?

The normal operation of bearings is inseparable from effective lubrication, but the harm of water to bearings may not be taken seriously by everyone. In fact, water has a great impact on the life of bearings. Only a small amount of water (close to 500ppm) can greatly reduce the life of rolling beari
How to install TIMKEN cylindrical roller bearings

Installation method: When using a tight fit inner ring, the installation method depends on whether the bearing has a straight or tapered bore. Then install the lock washer and lock nut or clamping end cover to fix the bearing on the shaft shoulder. After the bearing cools down gradually, tighten the
Several factors in selecting bearing types

1. Bearing radial loadThe bearing that mainly bears radial load is the radial bearing. The nominal contact angle of this type of bearing is a0<=45 0="" br="">N-type and NU-type cylindrical roller bearings can only bear radial loads, and other types of radial bearings can bear both radial loads and a